|Checking Material Strength||Snap Fasteners & Decorative Buttons||XIRIUS Flat Back Snap Fastener||Jeans Buttons||Rivets||Rose Pins & Rhombus Pins||Crystal Studs|
Rose Pins & Rhombus Pins
Pins can be easily applied using a fly press, a semi- or fully-automated attaching machine. The application with the fly press and the semi-automatic attaching machine will be explained step by step. Please note the material thickness when selecting Pins.
|PIN TYPE||ARTICLE||SIZE||MATERIAL THICKNESS*|
|ROSE PINS||53 301||SS 10||1.0 - 2.0 mm|
|53 302||SS 16||1.0 - 2.0 mm|
|53 303||SS 20||1.0 - 2.0 mm|
|53 304||SS 34||1.0 - 2.0 mm|
|RHOMBUS PINS||53 320||10 x 6 mm||1.0 - 2.0 mm|
* This can vary according to the roughness and production of the carrier material.
Application with a fly press
To apply Pins, attach the appropriate die to the fly press.
Note: Do not apply Pins on areas of the carrier material that are under high mechanical stress, such as critical parts of a shoe. After application, ensure the Pins are not heated up to more than 80 °C (176 °F).
Application with a semi-automatic attaching machine
To apply Rose Pins, the semi-automatic attaching machine must be adjusted to the Rose Pin size and carrier material (dies, feed and magazine). Please follow the machine manufacturer’s instructions (S.P.S. Tecnologia Meccanica).
Note: When applying Rose Pin motifs, it is helpful to have a corresponding template or marking on the carrier material to ensure the correct positioning.
Application with a Rose Pin mold/press
To apply Rose Pins a mold/press can be used. Therefore Rose Pins are sieved into cavities of the lower part of the mold by using PVC masks specific for each diameter/design. In a next step base material is put into the mold. By closing mold and adding pressure by using a press (simple cutting press) Rose Pins are applied onto base material simultaneously in one step.
Please also have a look on the comprehensive video of the application of Rose Pins with a press/mold.